Page 1 of 1
Is there a formula I should use.
Posted: Tue Dec 24, 2024 12:01 pm
by whitezin65
I work full time and run a small business. I don't have a whole lot of spare time. I'm not an engineer, nor do I possess a machine shop. However, I am good with my hands. I heat with a large indoor woodstove. I'd like to see a sterling engine run fan sitting on it. Maybe 2.
Is there a good tutorial thread here for something like that?
I'm also looking for information about what size things should be in relation to one another. Primary cylinder, displacer, power piston... if I found a couple of cans I'd like to work with, what size should everything else be? Is there a formula I should use?
Re: Is there a formula I should use.
Posted: Wed Dec 25, 2024 4:54 am
by whitezin65
FYI: When I click on the "free plans" link I get a prompt that says "page not available".
Re: Is there a formula I should use.
Posted: Wed Dec 25, 2024 8:22 am
by Tom Booth
whitezin65 wrote: ↑Tue Dec 24, 2024 12:01 pm
I work full time and run a small business. I don't have a whole lot of spare time. I'm not an engineer, nor do I possess a machine shop. However, I am good with my hands. I heat with a large indoor woodstove. I'd like to see a sterling engine run fan sitting on it. Maybe 2.
Is there a good tutorial thread here for something like that?
....
There is this thread from a few years ago where someone asked a similar question:
viewtopic.php?p=15913#p15913
Re: Is there a formula I should use.
Posted: Fri Dec 27, 2024 12:11 pm
by whitezin65
You have a wonderful sense of humor. I didn't get any answers then either. Guess this forum isn't worth much.
Re: Is there a formula I should use.
Posted: Fri Dec 27, 2024 12:40 pm
by Fool
.
Here is a link that has the same information as the plans page:
https://boydhouse.com/stirlingengine/index.html
.
Re: Is there a formula I should use.
Posted: Fri Dec 27, 2024 12:54 pm
by Fool
.
Also the Schmidt analysis can be used:
https://www.google.com/url?sa=t&source= ... 3srKMCFb56
Or the Beale equation and number:
https://en.m.wikipedia.org/wiki/Beale_number
I would stick with o 0.11 or even 0.1 until you get your own calculations of the number for your style of engines. It is only a starting point.
The Stirling Engine Design manual is large but well worth it. It is a free download PDF:
https://www.google.com/url?sa=t&source= ... FCsJNULIEe
If you help getting started just post here any questions. Please.
.