Page 1 of 1
alpha engine question
Posted: Wed Jan 24, 2018 9:27 am
by Wellington
Im currerntly building my first engine. Its a horizontal unpresurised mini alpha engine. How should i ofsett the crankshaft? does the displacer piston go 90 degrees ahead of the power piston? Thanks
Wellington.
Re: alpha engine question
Posted: Wed Jan 24, 2018 10:10 am
by cbstirling2
Well with alpha, both pistons and cylinders can be identical on same crank pin 90 apart.
Displacer is misnomer here. Either hot or cold piston.
Re: alpha engine question
Posted: Wed Jan 24, 2018 1:14 pm
by Wellington
cbstirling2 wrote:Well with alpha, both pistons and cylinders can be identical on same crank pin 90 apart.
Displacer is misnomer here. Either hot or cold piston.
]#
Its a horizontal engine that looks like a gamma so no right angle to put on same pin. Im trying to copy this engine:
https://www.youtube.com/watch?v=w5RkcP3QI50
regards
Wellington
Re: alpha engine question
Posted: Fri Jan 26, 2018 3:35 am
by Ian S C
You can actually run a parallel GAMMA on a single crank pin by running the displacer via a bell crank, and an ALPHA could be run the same way. On this motor the bell crank ratio is 1.5 : 1, for an ALPHA motor the ratio would be 1 : 1
Ian S C