Has anyone ever set up a stirling engine the same in picture ?????

[thanh-cuibap]

Hi everybody !! Has anyone ever set up a stirling engine the same in picture ?????

Assembly1-1.jpg (142.06 KiB) Viewed 7117 times

Assembly1.jpg (121.4 KiB) Viewed 7117 times

[Ian S C]

The convention is to use 90*as the nominal angle, and a V type with a movable cylinder, or a parallel type with an adjustable crank will allow adjustment of the phase angle. Adjust the angle a few degree at a time, checking the RPM and torque at each adjustment. Try 90* plus, until power drops off, go back to zero, then go 90* negative, mark the position of maximum power, it won't be too far from 90*.
Ian S C

[thanh-cuibap]

Thanks Ian !

[Ian S C]

It's probable that you could try 15* to 20* either side of 90*, this is a good experiment for a demonstration motor.
Ian S C

[thanh-cuibap]

Thanks Ian! I will try do it..