Page 3 of 3
Re: power for using an alternator for battery charging?
Posted: Wed Sep 18, 2013 2:43 am
by Ian S C
With the VCR motor, without much work you have a 3 phase alternator. The hub dyno is belt driven, as it's set up today the reduction is 2 :1, and with a load (transistor radio), the dyno was running at 110rpm. I'll have to get a photo of it, but I'm a bit busy on another motor at the moment, I'll get that finished, then I'll see about photographing a few bits and pieces. Ian S C
Re: power for using an alternator for battery charging?
Posted: Thu Sep 19, 2013 7:39 pm
by fullofhotair
Ian SC,
So as I understand it, Your stirling engine is running at 220rpm, and the dyno at 110rpm. If you ran the dyno straight, without reduction at 220rpm this would be too fast?
Re: power for using an alternator for battery charging?
Posted: Sat Sep 21, 2013 4:58 am
by Ian S C
full, no, but the voltage would be too high for the transistor radio that is the load. I have not had the ammeter on it to check the current, maybe I'll try that in the next day or so. Ian S C