Page 2 of 2
Re: alpha type stirling engine question
Posted: Mon Jul 28, 2014 5:29 pm
by quadriplegic
I will post mine, when I get it built. I'm using a 100 mm skate wheel for a flywheel, and ether 2 10 cm syringes or a 100 cm for a displacer piston and a 20 cm for the power piston. I plan on putting magnets on the flywheel and some coils to make some power.
Re: alpha type stirling engine question
Posted: Mon Jul 28, 2014 7:21 pm
by flash3780
That's a neat engine! I wonder if some steel wool in the tube between the hot end and cold end would improve your power output.
Chris
Re: alpha type stirling engine question
Posted: Mon Jul 28, 2014 10:10 pm
by mysticwolves
flash3780 wrote:That's a neat engine! I wonder if some steel wool in the tube between the hot end and cold end would improve your power output.
Chris
Thanks. I'll look into that if I make another one since I no longer have this one.
Re: alpha type stirling engine question
Posted: Fri Aug 01, 2014 3:50 am
by Ian S C
You might have to enlarge the airway to allow for the regenerator Ian S C