alpha type stirling engine question

[quadriplegic]

I will post mine, when I get it built. I'm using a 100 mm skate wheel for a flywheel, and ether 2 10 cm syringes or a 100 cm for a displacer piston and a 20 cm for the power piston. I plan on putting magnets on the flywheel and some coils to make some power.

[flash3780]

That's a neat engine! I wonder if some steel wool in the tube between the hot end and cold end would improve your power output.

Chris

[mysticwolves]

That's a neat engine! I wonder if some steel wool in the tube between the hot end and cold end would improve your power output.

Chris

Thanks. I'll look into that if I make another one since I no longer have this one.

[Ian S C]

You might have to enlarge the airway to allow for the regenerator Ian S C