when i said flexible joint join, then it could be that i have written the wrong word, i will use metal bend, who will go in a hole in the top of the dispencer rod
i can find the right words here in english..i will take a photo later today, think i will try paint it today, just for the fun of it!!
Displacer gap too big?,now with 2 cylinder building
-
Triangle.Stirling
- Posts: 133
- Joined: Mon Sep 09, 2013 8:29 am
Re: Displacer gap too big?,now with 2 cylinder building
Yes, i did understand what you meant with the 'flexible joint' just curious how are you doing that, because i'm also making a popcan engine. Actually i also don't know the right word for it :P
What do you have as a seal for the displacer rod?
What do you have as a seal for the displacer rod?
Re: Displacer gap too big?,now with 2 cylinder building
Hei
The seal for the displacer rod is a bronse bearing from a electric engine,its a thight fit, but i am thinking about to make a longer bearing/tube. i have taken a picture of the flexible joint',so you can see,but the flexible joint' connection is supposed to be lower down on the displacer rod."cause of lower friction then"
The seal for the displacer rod is a bronse bearing from a electric engine,its a thight fit, but i am thinking about to make a longer bearing/tube. i have taken a picture of the flexible joint',so you can see,but the flexible joint' connection is supposed to be lower down on the displacer rod."cause of lower friction then"
- cylinders paint.jpg (116.4 KiB) Viewed 3059 times
- cylinders paint2.jpg (103.46 KiB) Viewed 3059 times