A potential source of rigid plastic to make an LTD Displacer Cylinder is to be found in the housewares/kitchenwares section of department stores and the large sprawlmart stores.
Look for the vertical storage jars with a clamp down sealable top.
Select the appropriate size and cut to length on a band saw or table saw.
Finish the cut edges with 65/80, & 100/100+ sandpaper or wet or dry paper with water.
stanhbaker
LTD Displacer Cylinder Material
-
stanhbaker
- Posts: 30
- Joined: Wed May 31, 2006 5:14 pm
- Location: KnoxTn
LTD Displacer Cylinder Material
Why be difficult?.. When with just a little application you can be absolutely difficult!